Stacchiamo qualche minuto dalla solita routine delle notizie per iniziare a sbavare un po dietro al video che vi ho messo qua sotto:

Se siete abili, avete uno di quegli Android collezionabili e volete cimentarvi nell’impresa ecco quello di cui avete bisogno:

1 x Android Figure from DYZPLASTIC
1 x ATtiny44A from Mouser or Digikey
1 x 14 pin DIL socket
1 x Micro Servo SG90 (plastic) or MG90S (metal)
1 x Microphone e.g. CMC-5042PF-AC from Digikey
1 x Piezo (passive, not the buzzer kind)
2 x blue 5mm flat top wide angle LED from ebay
1 x red super bright 5mm LED
1 x green super bright 5mm LED
1 x yellow super bright 5mm LED
1 x NPN Transistor e.g. 2N3904
3 x 100nF ceramic capacitor
2 x 100K resistor
2 x 10K resistor
2 x 2K2 resistor (or other values depending on your blue LEDs)
3 x 150 resistor
1 x +5V power supply (e.g. USB charger)

Le istruzioni invece le trovate qui: http://www.instructables.com/id/Mechanized-Android-Figure/.

Se ci provate, ovviamente, fatecelo sapere! :D


[Via]